Classic Performance Products 378 E Orangethorpe Ave., Placentia CA 92870


Tubular Upper and Lower Control Arms

Classic Performance Products’ Tubular Control Arm set is designed to add 5° of caster while providing full wheel travel and minimal friction possible. They are made from 1-1/4” .120” wall D.O.M. tubing and the pivot barrels are thick 1-1/2” .188” wall D.O.M. tubing to eliminate distortion from welding and hard use. The bushings are made from self lubricating non-squeak patented plastic that will out last any rubber or urethane, and works at temperatures in excess of 400°F. The billet 4140-alloy steel cross shafts and sleeves are zinc plated for lasting performance.

The sleeves have an interlocking design that prevents the hardware from ever working loose. The pivots carry both forward and back loads (the original cross shaft pivot was designed to only carry a forward or back load, but not both). The control arm assemblies are a simple bolt-in installation with no modification required. They work with all factory and replacement power steering systems, and with or without O.E. bump stops. Note: Ball joints included.


Online Technical Library Print This Page

© Classic Performance Products. This "website" and all contents are property of Classic Performance Products.

Prices subject to change without notice. Not responsible for errors or omissions.