|Classic Performance Products Tubular Control Arm set
is designed to add 5° of caster while providing full wheel travel and
minimal friction possible. They are made from 1-1/4 .120 wall
D.O.M. tubing and the pivot barrels are thick 1-1/2 .188 wall
D.O.M. tubing to eliminate distortion from welding and hard use.The bushings
are made from self lubricating non-squeak patented plastic that will out
last any rubber or urethane, and works at temperatures in excess of 400°F.
The billet 4140-alloy steel cross shafts and sleeves are zinc plated for
lasting performance. The sleeves have an interlocking design that prevents
the hardware from ever working loose. The pivots carry both forward and
back loads (the original cross shaft pivot was designed to only carry a
forward or back load, but not both). The control arm assemblies are a simple
bolt-in installation with no modification required. They work with all factory
and replacement power steering systems, and with or without O.E. bump stops.
Also works with QA1 shocks and Shockwave kits.