Classic Performance Products Tubular Control Arm
set is designed to add 5° of caster while providing full wheel travel
and minimal friction possible. They are made from 1-1/4 .120
wall D.O.M. tubing and the pivot barrels are thick 1-1/2 .188
wall D.O.M. tubing to eliminate distortion from welding and hard use. The
bushings are made from self lubricating non-squeak patented plastic that
will out last any rubber or urethane, and works at temperatures in excess
of 400°F. The billet 4140-alloy steel cross shafts and sleeves are zinc
plated for lasting performance.
The sleeves have an interlocking design that prevents the
hardware from ever working loose. The pivots carry both forward and back
loads
(the original cross shaft pivot was designed to only carry a forward or
back load, but not both). The control arm assemblies are a simple bolt-in
installation with no modification required. They work with all factory and
replacement power steering systems, and with or without O.E. bump stops.
Note: Ball joints included. |