|
|
|
Though designed for use with TCI frames and suspension parts, the front
panard rod can be adapted to most any chassis using a 4-link, transverse
spring and a beam or tube axle. |
|
|
A |
Bolt axle mounting bracket to inside of passenger side 4-Link batwing with
bar mount at bottom. |
B |
Using assembled bar as a guide, position frame bracket (with open side towards
engine) on bottom of drivers side frame rail just behind the front crossmember.
Make sure that panard bar runs parallel to axle and then weld frame bracket
in place. |
|
|
All welding should be done by a qualified welder |