| |
INSTALLATION INSTRUCTIONS
DROP-OUT BATTERY BOX
Read these instructions completely before attempting this conversion:
Conversion kit requires the following components:
(4) Grade 8, 5/16" bolts. The length will depend upon the depth
of the frameit is bolted to.
(4) Lock washers
(4) Washers
(4) Self-Locking Nuts
- To mount the battery box, you will need to clear an area on the frame
to the dimensions of 12-1/4" wide x 8-1/4" deep from the frame
to the outside edge of the battery box as well as a clear area underneath
the box for the dropout
- Disassemble the receiver that bolts to the frame from the battery box.
Use the receiver as a pattern for drilling your mounting holes through
the frame. Note that we have designed a double bolt pattern in the receiver
so it can be used on either a 3", 4" or 6" wide frame.
- Bolt the receiver to the frame using the four grade 8 bolts, lock washers,
washers and nuts.
- Install the battery into the box and secure it in place with the provided
eye bolts. Note the position of the eybolts in the diagram below. Use the
slot on the back side of the battery box that best fits the size of your
battery. The box is designed for either a top post or side terminal battery.
- Slide the battery box up into the mounted receiver far enough to catch
in the first latch position. This is the "service" position.
- Connect the battery cables.
- Push the battery box up into the "locked" position.
|
|
