|Available in steel and chrome, these IDIDIT columns feature
the new style "curvy" cup. It has a 3/4" 36 lower shaft and
requires a rag joint. When installing, original under-dash mount will bolt
directly to this column as well as the original floor support will be used.
The ignition harness will require use of the terminals located in the original
ignition switch plug. The terminals will need to be removed from the original
plug and snapped into a new mating plug that is provided with each column.
The original wheel can then be bolted directly to the top of the column.
Note: If you are replacing a tilt column without column shift, the original
column had a neutral safety switch built into the steering column. It will
be necessary to locate a neutral safety switch on the transmission. IDIDIT's
column shift is built with a neutral safety switch included.